Giant 1-Feb Manual do Utilizador descarregar pdf (Página 8)

Installing the Hub in a Rack

FastHub 400 10/100 Series Installation and Configuration Guide

2-8

Installing the Hub in a Rack

This section describes how to install the hub in 19- and 24-inch standard and telco racks.

Note Be sure the hub is powered off and is not connected to a power source before you

perform the steps in the sections that follow.

Attaching the Brackets to the Hub

Thebracketorientationandthe screwsyouusedependonwhether you plan to use a19-inch

or a 24-inch rack:

• For a 19-inch rack-mount, use the Phillips ﬂat-head screws to attach the long sideof the

bracket to the hub.

• For a 24-inch rack-mount, use the Phillips truss-head screws to attach the short side of

the bracket to the hub.

Place the hub on a level surface, and use two of the supplied Phillips ﬂat-head or truss-head

screws to attach a mounting bracket to each side of the hub.

Figure 2-1, Figure 2-2, and Figure 2-3 show how to attach one bracket to one side of the

hub. Follow the same steps for the opposite side of the hub.

Figure 2-1 Attaching Brackets for 19- and 24-inch Racks (Front Panel Forward)

RPS

MODE

1x 2x 3x 4x 5x 6x 7x 8x

Phillips

flat-head

screws

19" configuration

H10730

RPS

MODE

1x 2x 3x 4x 5x 6x 7x 8x

H10731

Phillips

truss-head

screws

24" configuration

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 25 26

Sem comentários

Giant 1-Feb Manual do Utilizador Página 8